Rockwell Tools GUARDSHIELD SAFE 4 Manual de usuario Pagina 12

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 28
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 11
GuardShield™ Type 2 Safety Light Curtain Installation Instructions
10
R
Original instructions
Electrical Installation
Connections
Power Supply
The external voltage supply (+24V DC) must meet the requirements of
IEC 61496-1. In addition, the following requirements have to be
fulfilled:
A short-term power failure of 20 ms must be bridged by the power
supply.
The power supply has double insulation between the primary and
the secondary side.
The power supply is protected against overload.
The power supply corresponds to the guidelines of the EWG
(industrial environment).
The power supply corresponds to the Low Voltage Directives.
The grounded conductor of the power supply device must be
connected to a grounded conductor PE.
The maximum deviation of the voltage levels is 24V DC +/- 20%.
EDM Connection
Figure 9:
Connecting the contact elements to the EDM
Start/Restart interlock
Note: Start/restart interlock requires a N.O. momentary push button or
key switch.
Figure 10:
Connecting the reset button/restart button
Connections [mm (in.)]
Cables/Connectors
The GuardShield Type 2 transmitter connector is a four-pin DC micro
connector offered in cable lengths from 2 to 30 meters. The GuardShield
Type 2 receiver connector is an 8-pin DC micro connector offered in
cable lengths of 2 to 30 meters.
Standard GuardShield Type 2 Receiver Connector
Double insulation
This part of the insulation provides
supplementary insulation against
hazardous voltage levels.
Motor, etc.
Hazardous voltage level
Basic insulation
Hazardous Hazardous
Reinforced
insulation or
double
Unit 1
Power
Supply Unit
Output (pink
Basic insulation
Basic insulation
0V (blue)
+24V (brown)
K1
K1
K2
K2
GuardS
hield
24V
Pin 4
5
6
K1
K2
k2
k1
Contactor
Contacts
Contactor
Coils
Transmitter Connection
Face View of
Female DC Micro Color Pin No.
Signal
Transmitter
Brown 1 +24V DC
White 2 No Connection
Blue 3 0V DC
Black 4 Machine Test Signal
Receiver Connection
Face View of
Female DC Micro Color Pin No.
Signal
Receiver
White 1 Auxiliary Output
Brown 2 +24V DC
Green 3 Ground
Yel lo w 4 ED M
Grey 5 OSSD 1
Pink 6 OSSD 2
Blue 7 0V DC
Red 8 Start/Restart
Pin 8
Reset/restart button
24V
1
4
32
2
1
5
8
7
6
4
3
Vista de pagina 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comentarios a estos manuales

Sin comentarios